annealed
英 [əˈniːld]
美 [əˈniːld]
v. 给(金属、玻璃)退火
anneal的过去分词和过去式
双语例句
- Above this point the hardness can be increased only slightly, because steels above the eutectoid point are made up entirely of pearlite and cementite in the annealed state.
高于此点,由于超过共析点钢完全由珠光体和退火状态的渗碳体组成,硬度增加并不多。 - Microstructure and Residual Stress of Cu Films Annealed at Different Temperatures
退火温度对Cu膜微结构与应力的影响 - Bright heat treatment of stainless steel are martensitic stainless steel ( such as the400 series), bright quenching, austenitic stainless steel ( such as the300 series), bright annealed.
不锈钢的光亮热处理有马氏体不锈钢(如400系列)光亮淬火、奥氏体不锈钢(如300系列)光亮退火。 - Tools which have been repaired by welding must have been annealed under stress-free conditions.
补焊的模具需要进行无应力退火。 - These indicate that the film annealed at600 ℃ has the best crystalline quality.
这表明在600℃下退火的样品具有最好的晶化质量。 - Why shall harden steel be annealed?
淬火钢为什么要退火呢? - And cracks appear in the film because tensile stress is too large when the sample is annealed at400 centigrade.
在400℃退火后,由于张应力太大,薄膜表面出现了裂纹。 - Used annealed paving blocks.
使用韧化的铺地块料。 - Formation of the coarse grains in annealed low carbon steel sheets by EBSD analysis
低碳钢退火板中粗大晶粒成因的EBSD分析 - The dynamic change process of the crack coppicing and extending on annealed Q& P steel was in-situ observed by SEM, and the micro-crack characteristic was studied.
采用扫描电镜(SEM)原位拉伸观察了Q&P钢退火组织断裂过程中裂纹萌生和扩展的动态变化过程,并对其微观断裂特征进行了研究。