asperities

英 [æsˈpɛrɪtiz]

美 [əˈspɛrɪtiz]

n.  (尤指语言、态度)粗暴，严厉
asperity的复数

双语例句

• But the countries of the continent for a long time desperately struggled against all change, and would have diverted revolution by softening the asperities of absolute government.
  然而大陆各国长期以来拼命反抗一切改革，他们希望通过缓和专制政府的粗暴程度改变革命的方向。
• Merchant thought that minute asperities existed at the chip-tool interface and the fluid was drawn into the interface by the capillary action of the interlocking network of these surface asperities.
  Merchant认为：在切屑与刀具接触界面上存在微小的粗粒，切削液通过这些表面的微小粗粒组成连锁的网络的毛细管被吸入到切屑与刀具的接触界面上。
• The influence of density distribution and height of the asperities on nonlocal friction is also studied here. A experimental system for friction test is designed.
  分析了微凸体分布密度不同、微凸体高度不同时，非局部摩擦的影响变化规律。
• Numerical results reveal that the existence of single asperities can lead pressure to change drastically and film thickness to become thin in the vicinity of the asperities.
  结果表明，单粗糙峰造成接触区对应位置油膜压力剧烈变化而膜厚变薄。
• However, at higher angle of tooth-shaped asperities and under higher normal stress, the failure model II is found, which is in first tension but final shear failure.
  在较高的法向应力下，含起伏角较高齿形节理面的非贯通节理岩体可能出现破坏模式II（先张拉后剪切破坏模式）。
• Influences of the cavitations between the asperities on roughness surfaces on flow factors were investigated.
  研究了粗糙表面上微凸体间气穴对用于混合润滑分析的流量因子的影响。
• The size of the peaks, or asperities, depends on the material and the method of surface finishing.
  峰或突起的大小与材料和表面抛光方法有关。
• In this paper, a three-dimensional measuring system for surface asperities is described, in which a microcomputer is interfaced to a stylus profilometer.
  本文介绍采用触针式轮廓仪与通用微型机相连的表面三维形貌测量系统。
• The experiments indicated that asperities of roll surface plow and stick to the aluminum strip surface, and lubrication oil film in deformation zone shields surface topography of aluminum strip are the primary reasons of surface damage of cold rolled aluminum strip.
  实验发现：轧辊表面微凸体对铝板表面的犁削与粘结作用，以及变形区内润滑油膜对铝板表面形貌的屏蔽作用是冷轧铝板表面损伤的主要原因。
• Undoubtedly, these asperities will have remarkable influence on surface friction and subsurface stress of the contact area.
  齿面粗糙峰的存在无疑会对齿面摩擦力和轮齿接触区次表面应力分布产生重大影响。