slivers

英 [ˈslɪvəz]

美 [ˈslɪvərz]

n.  (切下或碎裂的)小块，薄片
sliver的第三人称单数和复数

柯林斯词典

• N-COUNT 小片;一点儿
  Asliver ofsomething is a small thin piece or amount of it.
  1. Not a sliver of glass remains where the windows were...
     窗户上连一点儿玻璃碎片都没有留下。
  2. There was only one sliver of light in the darkness.
     黑暗中只有一点零星的光亮。

双语例句

• The cleaning should not be done with steel wool, because of the likelihood of leaving small slivers of the steel or oil in the joint.
  不应该用钢丝绒进行清理，因为细小的钢丝绒长条可能会残留或被油污粘在连接部位。
• These slivers can be further reduced in diameter and then twisted and plied in yarns of various sizes using textile machinery and processes similar to those employed for other staple materials.
  这些纱条的直径可以进一步减小，然后经过加捻、合股，采用与其它纤维材料加工类似的工艺，制成不同规格的纱线。
• Transverse structure and model of fault slivers in the northern part of the Tarim block
  塔里木地块北部横向构造及断条模式
• An isotope method of testing the weight of slivers
  棉条重量的放射性检测方法
• The test shows that double press bar top pin in back zone draft set has bigger control of slivers in back zone, and can enhance back zone draft ability of spinning frame, increase draft multiple, and enhance fine count yarn quality.
  结果表明：后区附双根压力棒新型上销牵伸装置对后牵伸区须条的控制增强，可以提高细纱机的后区牵伸能力，增大总牵伸倍数，有利于细号纱纺纱质量的提高。
• There may be slivers of positive, but I view this as sobering.
  有人会看到积极的一面，但我认为对此应保持清醒。
• Model BS368 Lap Draw Frame is a high efficient preparation machine for Comber, easy operation, high automation and reasonable doubling of slivers and drafting ratio.
  BS368型条并卷机是高效的精梳准备设备，操作简单，自动化程度高，棉条合并数、牵伸倍数分配合理。
• A method to analyze the frequency spectrum of yarns and slivers unevenness signal
  对纱条不匀信号频谱分析的方法
• It was found that fibers of circular cross section produce greater cohesion in webs and slivers than do trilobal fibers.
  圆形横截面纤维在棉网和棉条中，比三叶形横截面纤维能产生较大的粘着作用。
• Conversion of caster from the curved to the vertical bending one is the most effective measures to eliminate the pipe listers and slivers for cold rolled Ti SULCAK ( Ti-beating extra low carbon steel sheet).
  为了消除TiSULCAK（含Ti超低碳铝脱氧镇静钢）钢冷轧薄板上的铅笔型气泡，将铸机从弧型改为立弯型是最有效的措施；